 |
|
|
The Poly – stick self adhesive water proofing membranes are an SBS polymer modified Bitumen membrane having a high density cross Limited polyethylene film on one side and the other side with a silicon coated release film.
|
POLY – STICK should be laid on clean dry firm surface free on loose particles. Application temp to be between 4° C to 45 °C.
Apply a coat of bitumen primer @ 0.20 ltrs./sq. mtr. & allow to dry.
Lay the POLY – STICK membrane after peeling off the release film. Ensure overlaps of 75 to 100mm.
Place the protection board on top of the membranes to prevent any damage from Exposure to sunlight backfilling etc.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Tensile strength [L/T/N/5cm
|
|
|
|
Penetration at 25°C /100/5sec |
|
|
|
|
|
|
Water absorption 25°C for24 hrs. |
|
|
|
|
|
|
|
|
|
Resistance to Ageing > 200hrs. |
|
|
Cold applied, Excellent adhesion to vertical and horizontal surface, Resistance to chlorides, sulphates, acids, alkalis, heat, tear, and puncture. Water and vapour proof. |
Storage Handling & Safety : |
POLY- STICK should be stored vertically in cool dry covered area . Direct Contact with sunlight & Fire to be avoided. Gloves, goggles , boots & masks recommended while application. Care to be taken during loading & unloading to avoid damages. |
|
|
